Before determining the size of the pump to the well, you need t

  •   If your Stainless Steel Submersible Sewage Pump does not match the water depth, please expect the pump to turn on or off or continue to run unnecessarily, thereby shortening its life and increasing electricity bills. The depth of the well determines the type of pump you need, because some pumps push water from deep inside the well to the surface, or pump water away. When you know the correct type of pump to use, the pressure tank or storage tank adjacent to the pump can ensure continuous water supply when needed.

      Adjust the size of the Stainless Steel Submersible Sewage Pump

      Before determining the size of the pump to the well, you need to know the depth of the well, its static water level (the size from the surface to the water surface), and its recovery rate. When the contractor was drilling, he noticed these details in order to obtain a permit. The paperwork he provides to you should also include this information so that you can choose a pump that matches the depth and output of the well. Each well produces water at a different rate, depending on the underlying formation. Local health and construction jurisdictions issue well permits and set minimum standards for good production, which range from 1 to 5 gallons per minute or higher.

      Shallow Well Pump

      The pump installed on the ground draws water from the well by pulling force. This type of pump can only be used in wells 25 feet or deeper. These types of pumps usually also require a booster or a water storage tank to increase the amount of water delivered in the pipeline, in pounds per square inch. The pump sends the water to the storage tank for use.

      Jet pump

      There are two options for jet pumps, shallow wells or deep wells. Both types of pumps are located above the ground. Shallow well jet pumps pump water from a pipeline located in a well no more than 25 feet deep. The deep well jet pump uses two pipelines, one for pumping water and the other for pushing water into the delivery system. Deep-well jet pumps can pump water from wells 25 to 110 feet deep.

      Deep well pump

      Deep well pumps are installed in wells from 25 to 400 feet deep and are measured in horsepower and gallons per minute. The pump is submerged deep in the well, below the static water level, but not at the bottom of the well. A pressure tank is usually installed next to the pump, and the pump will not cycle until the pressure tank drops below a certain level. The pressure tank or storage tank is located a few feet from the wellhead. A pressure regulator installed in series after the water tank controls the water pressure in the pipeline and the flow to the water tank. When the water tank is full, it will shut down the pump. The three-line pump uses a control unit on the ground, so it is easier to repair.

      Small Submersible Pump is also our product, welcome to consult and purchase.